Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it’s worth understanding the basics before comparing specific units.
The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.
If you’re still working out which process fits your workload, it helps to talk it through with people who field these questions every day rather than guess from a spec sheet, and the team behind they said in Thirsk deal with exactly this kind of query on the advice line.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they’re made from and what they’re used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn’t flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.
A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, oil or an undersized compressor, is one of the most common causes of poor cut quality and shortened consumable life, so it’s worth checking a machine’s air requirements against what your compressor can actually deliver before you buy, not after.
